I2C Basic Setup
Posted: Thu Dec 03, 2015 4:51 am
I would like to use I2C on a LPS331AP sensor IC. I am struggling with I2C on the Vocore.
Can somebody perhaps post a simple recipe to setup I2C on the Vocore ? I am a beginner with OpenWrt and Linux.
My connections are: (not sure if this is correct)
BOARD VCC -> VoCore 3.3V
BOARD GND -> VoCore GND
BOARD SCL -> VoCore G#02/I2C_SCLK
BOARD SDA -> VoCore G#01/I2C_SD
I have a white Vocore v1.0 and Linux command uname -a reports:
Linux OpenWrt 3.10.49 #4 Tue Sep 15 22:04:56 EDT 2015 mips GNU/Linux
Can somebody perhaps post a simple recipe to setup I2C on the Vocore ? I am a beginner with OpenWrt and Linux.
My connections are: (not sure if this is correct)
BOARD VCC -> VoCore 3.3V
BOARD GND -> VoCore GND
BOARD SCL -> VoCore G#02/I2C_SCLK
BOARD SDA -> VoCore G#01/I2C_SD
I have a white Vocore v1.0 and Linux command uname -a reports:
Linux OpenWrt 3.10.49 #4 Tue Sep 15 22:04:56 EDT 2015 mips GNU/Linux