I had download vocore firmware form: http://vonger.cn/?p=1637
And I followed Upload Firmware topic: http://vocore.io/wiki/index/id:14
to upload firmware, after few minutes, my NB network was been disconnected, I think step 1 of upper link was done.
So I had vocore powering down and powering up, pressing x for entering uboot console, then key in "loadb", screenshot is below:
Then I press down CTRL, \ key, then press C, the screenshot is below:
I don't know how to do the following step, could anybody help me?
thanks.
How to finish firmware upload
- yanunix
- Posts: 2
- Joined: Thu Dec 11, 2014 11:03 am
- jmendeth
- Posts: 6
- Joined: Wed Dec 10, 2014 6:54 pm
Re: How to finish firmware upload
Kermit is a way of transferring binary data over the serial adapter. Once you issue the loadm command, the VoCore is waiting for you to send it the firmware image using Kermit.
There are many programs that will allow you to do that. In the tutorial it tells you to use C-Kermit, but that doesn't run on Windows AFAIK. See https://en.wikipedia.org/wiki/Kermit_%28protocol%29.
There are many programs that will allow you to do that. In the tutorial it tells you to use C-Kermit, but that doesn't run on Windows AFAIK. See https://en.wikipedia.org/wiki/Kermit_%28protocol%29.
- Vonger
- Posts: 896
- Joined: Sun Oct 19, 2014 6:00 am
- yanunix
- Posts: 2
- Joined: Thu Dec 11, 2014 11:03 am
Re: How to finish firmware upload
I cannot open LUCI page, could you teach me how to check if some process has not been start?
4 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 43 guests