Hi,
this is the first setup of daylight simulation inspired by the "hack your sleep" movement:
https://www.youtube.com/watch?v=Fbn3wK_wApM
https://plus.google.com/109111823024526 ... n4BepRLV34
I just had one problem: I wrote the startup script (/etc/rc.common file) in a way it does not stop (because I did not background it). So boot is stuck in an endless loop with lamp blinking. Neither Wifi nor ethernet is initialized so I don't have any access on my vocore. Should I solder the UART pins to it? Is this a way to get back the control over my vocore?
Showroom: Daylight hacking with Vocore GPIO
- carli
- Posts: 1
- Joined: Sun Dec 14, 2014 7:41 pm
- Vonger
- Posts: 897
- Joined: Sun Oct 19, 2014 6:00 am
Re: Showroom: Daylight hacking with Vocore GPIO
One way is to flash a new firmware through uboot(tftp or kermit), details can be find in wiki.
Or connect UART and kill the dead loop.
Or connect UART and kill the dead loop.
2 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest