VoCore Forum

Posted: **Tue Mar 03, 2015 3:30 am**

I notice that he's referencing the actual original file at the top:

/include/ "rt5350.dtsi"

That's great and all, so... do I create another dtsi file? dts file? If so, what am I to call it? Does this then require referencing somewhere else in the makefile or perhaps the .config file generated by the menuconfig script?

Please keep in mind a lot of us are new to openWRT; any additional guidance is immensely appreciated.

Posted: **Mon Mar 09, 2015 5:01 am**

dont you just edit vocore.dts ?

Posted: **Mon Mar 09, 2015 6:06 am**

It worked apperantly

Posted: **Sat Apr 11, 2015 9:56 pm**

What voltage does this full UART use?
Is it standard serial voltage, 12V, or it is the Vocore standard GPIO voltage, 3.3 volts?

Posted: **Sun Apr 12, 2015 4:06 pm**

ion.dulgheru wrote:What voltage does this full UART use?
Is it standard serial voltage, 12V, or it is the Vocore standard GPIO voltage, 3.3 volts?

it is 3.3V,, and it is TTL

Posted: **Thu May 07, 2015 8:29 am**

i also want to use the second uart。how can i start it。how can i do with the dts。thanks~

Posted: **Fri May 08, 2015 3:08 am**

check this blog http://vonger.cn/?p=1409

VoCore Forum

Needing more detail on getting second UART working

Needing more detail on getting second UART working

Re: Needing more detail on getting second UART working

Re: Needing more detail on getting second UART working

Re: Needing more detail on getting second UART working

Re: Needing more detail on getting second UART working

Re: Needing more detail on getting second UART working

Re: Needing more detail on getting second UART working