hi,
As I can see in the SCH file, Vocore only has RF TX circuit on the file, while WL_RF0_2G_INP, WL_RF0_2G_INN pins are left floating.
How does Vocore handle the RF RX circuit?
I may have take it the wrong way, please help me out. Many thanks.
How does Vocore handle the RF RX circuit
- ansonc
- Posts: 5
- Joined: Tue Jun 16, 2015 11:23 am
- Vonger
- Posts: 896
- Joined: Sun Oct 19, 2014 6:00 am
Re: How does Vocore handle the RF RX circuit
I should study on this, from beginning I just follow ralink design, did not spend much time on that. Maybe you are right, just need to try and find out.
- ansonc
- Posts: 5
- Joined: Tue Jun 16, 2015 11:23 am
Re: How does Vocore handle the RF RX circuit
Hi, Vonger
The ralink reference design I have has both TX and RX path on board.
If your reference is only TX needed or any thing different, please send me a copy.
Thanks.
Anson
The ralink reference design I have has both TX and RX path on board.
If your reference is only TX needed or any thing different, please send me a copy.
Thanks.
Anson
- ansonc
- Posts: 5
- Joined: Tue Jun 16, 2015 11:23 am
Re: How does Vocore handle the RF RX circuit
hello? still no reply? Or if it is of no value at the point of figure out?
- Vonger
- Posts: 896
- Joined: Sun Oct 19, 2014 6:00 am
Re: How does Vocore handle the RF RX circuit
Not sure about that.
It just work.
It just work.
- ansonc
- Posts: 5
- Joined: Tue Jun 16, 2015 11:23 am
6 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 67 guests