Page 1 of 1
How does Vocore handle the RF RX circuit
Posted: Tue Jun 16, 2015 12:56 pm
by ansonc
hi,
As I can see in the SCH file, Vocore only has RF TX circuit on the file, while WL_RF0_2G_INP, WL_RF0_2G_INN pins are left floating.
How does Vocore handle the RF RX circuit?
I may have take it the wrong way, please help me out. Many thanks.
Re: How does Vocore handle the RF RX circuit
Posted: Sat Jun 20, 2015 2:57 am
by Vonger
I should study on this, from beginning I just follow ralink design, did not spend much time on that. Maybe you are right, just need to try and find out.
Re: How does Vocore handle the RF RX circuit
Posted: Sun Jun 21, 2015 3:05 am
by ansonc
Hi, Vonger
The ralink reference design I have has both TX and RX path on board.
If your reference is only TX needed or any thing different, please send me a copy.
Thanks.
Anson
Re: How does Vocore handle the RF RX circuit
Posted: Mon Jun 29, 2015 3:47 pm
by ansonc
hello? still no reply? Or if it is of no value at the point of figure out?
Re: How does Vocore handle the RF RX circuit
Posted: Tue Jun 30, 2015 4:58 pm
by Vonger
Not sure about that.
It just work.
Re: How does Vocore handle the RF RX circuit
Posted: Thu Jul 02, 2015 3:12 am
by ansonc
lol, not cool.
