Received my 3 vocore/docks yesterday.
I installed a development environment and build OpenWRT with Perl support.
I'd love to install it to see if it worked if only I knew how to recover from a bad flash AND where to get the original firmware.
Is anyone fluent in "vocorese"?
Recovery from bad flash?
- Ingmar
- Posts: 12
- Joined: Mon Nov 03, 2014 12:45 pm
- charliex
- Posts: 42
- Joined: Sun Nov 16, 2014 5:34 pm
- Location: los angeles
Re: Recovery from bad flash?
i posted some info on flashing firmware in the new to vocore thread, you can backup the config with luci or from the console with sysupgrade
openwrt houses firmwares http://downloads.openwrt.org/ if you can't build it, but the default vocore openwrt firmware doesn't have wifi enabled or luci, if i recall.
you can probably back up the mtd with dd, but i havent tried it yet.
openwrt houses firmwares http://downloads.openwrt.org/ if you can't build it, but the default vocore openwrt firmware doesn't have wifi enabled or luci, if i recall.
you can probably back up the mtd with dd, but i havent tried it yet.
- Ingmar
- Posts: 12
- Joined: Mon Nov 03, 2014 12:45 pm
Re: Recovery from bad flash?
Thx Charliex.
I also posted a new reply on your "notes for new users" topic. Any chance you can turn that thread in some kind of "vocore development manual"?
I also posted a new reply on your "notes for new users" topic. Any chance you can turn that thread in some kind of "vocore development manual"?
3 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 58 guests