Hello,
I want compile a new openwrt, using this Guide:
http://vonger.cn/?p=1585
But I got the error
make -r world: build failed. Please re-run make with V=s to see what's going on
make: *** [world] Fehler 1
Has anybody an idea what is wrong?
Compiling openwrt - error
- Kampi
- Posts: 14
- Joined: Tue Nov 25, 2014 6:50 am
- darksoul
- Posts: 45
- Joined: Fri Nov 14, 2014 2:29 am
Re: Compiling openwrt - error
Try to build like this: make V=s
You will get log where you have errors.
You will get log where you have errors.
- Kampi
- Posts: 14
- Joined: Tue Nov 25, 2014 6:50 am
Re: Compiling openwrt - error
Hello,
found the misstake. I have compiled it with
make -j 4
again and now I got no errors.
found the misstake. I have compiled it with
make -j 4
again and now I got no errors.
- Ton
- Posts: 22
- Joined: Sun Nov 16, 2014 4:35 pm
Re: Compiling openwrt - error
Following that tutorial I had two problems:
g++ is needed, but not installed. Do you need to do
sudo apt-get install build-essentials
to get that?
Secondly, I get an error:
/reset.c:90:3: error: implicit declaration of function 'mdelay'
I think the file is in:
/home/ton/openwrt/build_dir/target-mipsel_24kec+dsp_uClibc-0.9.33.2/linux-ramips_rt305x/linux-3.14.18/arch/mips/ralink
I can add #include <linux/delay.h> to reset.c, but from the tutorial I expect the thing to compile without errors?
g++ is needed, but not installed. Do you need to do
sudo apt-get install build-essentials
to get that?
Secondly, I get an error:
/reset.c:90:3: error: implicit declaration of function 'mdelay'
I think the file is in:
/home/ton/openwrt/build_dir/target-mipsel_24kec+dsp_uClibc-0.9.33.2/linux-ramips_rt305x/linux-3.14.18/arch/mips/ralink
I can add #include <linux/delay.h> to reset.c, but from the tutorial I expect the thing to compile without errors?
- charliex
- Posts: 42
- Joined: Sun Nov 16, 2014 5:34 pm
- Location: los angeles
Re: Compiling openwrt - error
it should compile without errors, i just pulled the main git tree and compiled it.
-j 4 shouldn't fix errors, all that does is run parallel steps in the makefile where it can.
-j 4 shouldn't fix errors, all that does is run parallel steps in the makefile where it can.
- Peter H
- Posts: 58
- Joined: Wed Nov 12, 2014 10:24 pm
Re: Compiling openwrt - error
It took me a couple of days to get OpenWRT to build, just because one of the GIT repos it needed was inaccessible. You don't say what the original error was, but if it was a network access problem, it might just fix itself after a few hours or days.
- Ton
- Posts: 22
- Joined: Sun Nov 16, 2014 4:35 pm
Re: Compiling openwrt - error
Yes, mine is compiling ok now. probably a hickup somewhere
7 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 80 guests