Can't go through system flashing
Posted: Tue Apr 18, 2017 8:38 pm
Hi,
I am new to the VoCore and following the Tutorial, I have Connect to Power, set up serial application to 115200bps, 8 data bits, no even, 1 stop bit, set up AP + STA Mode. But when I came to the system flashing, it never goes through and stays at
System - Flashing...
The system is flashing now.
DO NOT POWER OFF THE DEVICE!
Wait a few minutes before you try to reconnect. It might be necessary to renew the address of your computer to reach the device again, depending on your settings.
Loading Waiting for changes to be applied...
The VoCore has its yellow and purple lights on and my computer is connected to it through wireless.
Can anybody help me?
Regards,
SOHO
I am new to the VoCore and following the Tutorial, I have Connect to Power, set up serial application to 115200bps, 8 data bits, no even, 1 stop bit, set up AP + STA Mode. But when I came to the system flashing, it never goes through and stays at
System - Flashing...
The system is flashing now.
DO NOT POWER OFF THE DEVICE!
Wait a few minutes before you try to reconnect. It might be necessary to renew the address of your computer to reach the device again, depending on your settings.
Loading Waiting for changes to be applied...
The VoCore has its yellow and purple lights on and my computer is connected to it through wireless.
Can anybody help me?
Regards,
SOHO