VoCore2 keeps resetting on boot
Posted: Wed Jan 30, 2019 4:24 pm
OK, I have had my VoCore 2 Ultimate for quite some time and have just started to try and use it.
When I apply power and connect to a serial port I can see it trying to boot but it just keeps going around the boot cycle. I have flashed the most recent firmware and bootloader but this has made no difference. I am using Tera Term and have captured a TTY log of the cycle for a few minutes. Any suggestions on what I might be able to try in failsafe mode?
Attached is the TTY capture.
Thanks in advance,
Mark
When I apply power and connect to a serial port I can see it trying to boot but it just keeps going around the boot cycle. I have flashed the most recent firmware and bootloader but this has made no difference. I am using Tera Term and have captured a TTY log of the cycle for a few minutes. Any suggestions on what I might be able to try in failsafe mode?
Attached is the TTY capture.
Thanks in advance,
Mark