Uboot baudrate
Posted: Wed Nov 25, 2015 9:39 pm
Hi,
I was just wondering if it was possible to change the baudrate for uboot? ( I need to set it lower to 19200 for the project ).
I've tried "setenv baudrate 19200" but the confirmation prompt that comes up after doesn't work at the new baud. To continue I need to set kermit back to 57600bps.
If I saveenv, then restart, printenv shows the new baudrate but the console still operates at the old baudrate (57600). Is there a way to change it?
Also does the openwrt take the console settings from uboot or should I compile the settings into openwrt?
Thanks
I was just wondering if it was possible to change the baudrate for uboot? ( I need to set it lower to 19200 for the project ).
I've tried "setenv baudrate 19200" but the confirmation prompt that comes up after doesn't work at the new baud. To continue I need to set kermit back to 57600bps.
If I saveenv, then restart, printenv shows the new baudrate but the console still operates at the old baudrate (57600). Is there a way to change it?
Also does the openwrt take the console settings from uboot or should I compile the settings into openwrt?
Thanks