I seen he had the plug to the 3.3 volt on the RS232. He must of plug it back in wrong. So I put it right.
Can look at the boot up and it stops like this:
- Code: Select all
procd: - early -
procd: - watchdog -
procd: - ubus -
procd: - init -
Please press Enter to activate this console.
procd: - init complete -
/sbin/askfirst: Please press Enter to activate this console.
/sbin/askfirst: Please press Enter to activate this console.
[ 44.460000] random: nonblocking pool is initialized
/sbin/askfirst: Please press Enter to activate this console.
Is there a way though the RS232 to set it back to like factory default?
I can hit X to go to:
- Code: Select all
U-Boot for VoCore(based on RT5350)Warning: un-recognized chip ID, please update bootloader!
.
Version: May 30 2014 20:52:36
Press 'x' to console...
.
VoCore>
Any thing I can do from that to make this work again?
-Raymond Day