Hi, how can I connect vocore2 to another device using UART?
I saw that you said it should be the same as doing the same on a Raspberry Pi, so I found this article:
https://www.circuits.dk/setup-raspberry-pi-3-gpio-uart/
So I need to edit config.txt and the kernel cmdline?
Do I need to map GPIO?
I'm an IT person and not good at electronics etc, so please help and many thanks!
Connect Vocore2 to another device via UART
- im_chc
- Posts: 4
- Joined: Wed Nov 23, 2022 2:10 am
1 post
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests